If you're running the S-plus version, you
should also note that this command may cause S-plus to consume
huge amounts of memory -- after hours of simulation S-plus may suddenly
decide to terminate because of too little memory. Note that these
problems with S-plus also turns up in likelihood ratio tests
(see section 8). One solution to
this is to call bootstrap several times with nboots
set to some small number (e.g. 50 if you have about 64MB of memory).
You may also try to run the the R-version which does not have
these problems with memory.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.